The table below will help you fix the device.
Curtis coffee maker water level error.
Curtis coffee maker troubleshooting coffee maker is a simple device but it can also break down due to wear and tear misuse rare scaling power surges and other reasons.
If water is flowing in both the on and off positions the water inlet valve will need to be replaced by an authorized technician.
My g3 brewer is indicating a water level error what should i check.
Does the tank start filling.
Either issue should be checked and repaired by.
Control will display when temperature reaches the setpoint 200 f.
The heating tank will start to fill.
Broken water inlet valve turn the switch from on to off.
Unit is now ready to brew.
It takes approxi mately 20 minutes to reach setpoint temperature of 200 f.
One minute while the other equipment is drawing water.
Setup steps all coffee brewers regardless of brand should be level left to right and front to back and located on a solid coun ter top.
Reset the rear toggle switch the board should display filling heating ready to brew.
Ensure that there is a flow rate of 1 gpm.
Verify that the water supply to the brewer is on.
With the g3 gold cup series there is no danger of element.
In other words you can disable the water volume level controls.
If yes replace the water filter.
Perfecting the art of brewing since 1941 curtis manufactures a full line of commercial coffee brewing equipment iced tea brewing systems cappuccino dispensers and more.
Remove the orange wire from the probe.
Your curtis g3 gold cup series is.
If not con sult a plumber.
When the proper level is reached will appear on the screen.
Water will fill the tank approximately 2 3 minutes depending on water flow rate.
When the water level in the tank rises to the correct volume the heating element will energize automatically.
Connect a water line from the water filter to the brewer.
Does the lcd read water level error.
Coffee maker curtis gem 612ild installation instructions service warranty information digital gemini high volume brewing systems 5 pages coffee maker curtis thermopro g4 service manual.
Check that the inlet valve is operating correctly.
Basically the coffee machine can be set up so that no one can adjust the water level.
If not ensure that the inlet side of the water filter is receiving a minimum of 1 gpm.
Electrical issues the coffee maker could have problems with the water probe or universal control module.
If you ve had no luck it is probably because the machine is set to not allow you to adjust the settings.
